Embedded Communications Systems RMX232 Guide de l'utilisateur télécharger pdf (Page 11)

problems. Inadequate performance from the bench test may require fine tuning of the

configuration parameters.

It is recommended that for any new site installation a radio site test be performed. This

can be accomplished using the ping and radar diagnostic functions built in to the

Radio Modem. The diagnostic functions are explained in detail later.

If an installed system exhibits poor performance, both the radio path and possible

interference sources should be checked. Again the diagnostic functions ping and radar

can be used to check for these conditions. A high failure rate reported by the radar test

may indicate either the presence of interference or an inadequate radio path.

User’s Guide Installation 2-5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 42 43

Pas de commentaire

Embedded Communications Systems RMX232 Guide de l'utilisateur Page 11